This is an old revision of the document!
Inner Frame
Author: Friedrich Beckmann
The inner frame is 3D printed.
Design Data and Print
The design data is in the . The frame is composed of
- Sidewall-left
- Sidewall-right
- Innerwall
- pixracerplate
- gpsplate
The 3D Print for the walls is done with Ultimaker 3 with “Normal” default print settings plus 2mm wall width. The plates are printed with “Normal” Settings with the Ultimaker 2+. After the print:
- Remove the support brim by hand
- Remove the remaining support brim parts from the walls by filing. The innerwall has to fit into the sidewalls.
- The sidewalls have a 10mm hole and a 4mm hole for the fuselage spar beams. After print the beams do not fit.
- Drill a 10mm and a 4mm hole with the stand drill machine to make the fit. DO NOT USE A HAND DRILL!
- Check that the fuselage beams can be inserted in the sidewall holes.
