91����

Today (10.2.2019) the firmware for the PX4 is a custom build based on the 1.8.2 release. The firmware is maintained in the github repository:

This is a fork from the maintained by PX4 team. I have contributed two commits to the firmware which landed in upstream

The above changes to the upstream firmware are after the 1.8.2 release. I cherry-picked the above changes and applied them to the stable (1.8.2) branch. All changes for searchwing are maintained in the

which branched off the stable branch from upstream. The changes for the reduced Telemetry2 activity are missing.

The build command for the 1.8.2 based firmeware is

make px4fmu-v4_default

Note the missing “_” compared to the . You can find out the possible build targets via

make help
make list_config_targets

The firmware is on the PixRacer via the QGroundControl Software. You have to select the “Custom Firmware File” that you find in the folder “Firmware/build”. The name of the firmware file is “px4fmu-v4_default.px4”.

Make sure that only the mag sensor in the GPS Module is enabled. The two mag sensors in the pixracer should be disabled, because there is too much disturbance from the power cable below the autopilot. When the is installed with the arrow showing forward, then the mag sensor has a rotation of 90 Degrees Yaw (yes, this is strange). The parameters have to be setup like this

• CAL_MAG0_EN=1 (Enabled)
• CAL_MAG0_ROT=2 (Yaw 90 Degrees)
• CAL_MAG1_EN=CAL_MAG2_EN=0 (Disabled)

After the mag setup is changed, the mag sensors have to be calibrated. If you see a “Mag Inconsistent Error” in QGC, then this setup is wrong.

• Based on upstream 1.8.2
• Added X-UAV Mini Talon Airframe
• searchwing-1.8.2-1.px4.zip

• Added Björns minimal telemetry patch for the Raspberry Pi Camera Trigger from the autopilot
• searchwing-1.8.2-2.px4.zip