Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
searchwing-rfd868-mount [2020/02/17 12:40] j0ge4622 |
searchwing-rfd868-mount [2021/04/24 14:27] (current) beckmanf add note |
||
---|---|---|---|
Line 34: | Line 34: | ||
Pin layout of the Pixracer | Pin layout of the Pixracer | ||
- | {{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 |}} | + | {{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 | Pixracer board}} |
Pin layout to the RFD868+ | Pin layout to the RFD868+ | ||
- | {{ :pixacer-pinlayout_telem1.jpg?direct&400 |}} | + | {{ :pixacer-pinlayout_telem1.jpg?direct&400 | JST-GH telemetry cable connector}} |
- | Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | + | **Note the difference between the yellow cable named TX on the board and RX on the connector!!! The name RX for the yellow cable on the JST-GH cable connector refers to the RX on the RFD868 modem.** Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: |
- | ^ PixRacer JST-GH connector ^ RFD868+ IDC connector ^ | + | ^ PixRacer JST-GH board ^ RFD868+ IDC connector ^ |
| GND | GND | | | GND | GND | | ||
| RX | TX | | | RX | TX | | ||
Line 57: | Line 57: | ||
==== Power Module to RFD868+ modem cable ==== | ==== Power Module to RFD868+ modem cable ==== | ||
- | Ìý | + | * 4x 8" JST already crimped cableÌý |
- | Stromversorgung zu PowerModuleÌý | + | * JST 4-pin to female connector 8-pinÌý |
- | * 4 mal 8" vorgekrimpt auf JSTÌý | + | * GND + GND, 5V + 5V (double cable) |
- | * JST 4-polig auf Buchsenleiste 8-polig Ìý | + | |
- | * GND + GND, 5V + 5V (doppelte Kabel) | + | |
{{ ::powermodule-pinlayout_5v.jpg?direct |}} | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
- | Zur Kennzeichnung kann z.B. 10mm Schrumpfschlauch verwendet werden.Ìý | + | To mark the cable use colored shrink tube. |
- | Ìý | + | |
- | Ìý | + |