Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
searchwing-rfd868-mount [2020/02/16 13:44] beckmanf remove cable markings |
searchwing-rfd868-mount [2021/04/24 14:27] (current) beckmanf add note |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| {{::sw-telem-uart.jpg?600|}} | {{::sw-telem-uart.jpg?600|}} | ||
| - | Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | + | Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]]Ìý |
| + | Please note the different directions of the connector/cables in the labeling. | ||
| - | ^ PixRacer JST-GH connector ^ RFD868+ IDC connector ^ | + | Pin layout of the PixracerÌý |
| + | {{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 | Pixracer board}}Ìý | ||
| + | Ìý | ||
| + | Pin layout to the RFD868+Ìý | ||
| + | {{ :pixacer-pinlayout_telem1.jpg?direct&400 | JST-GH telemetry cable connector}}Ìý | ||
| + | Ìý | ||
| + | **Note the difference between the yellow cable named TX on the board and RX on the connector!!! The name RX for the yellow cable on the JST-GH cable connector refers to the RX on the RFD868 modem.** Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table:Ìý | ||
| + | Ìý | ||
| + | ^ PixRacer JST-GH board ^ RFD868+ IDC connector ^ | ||
| | GND | GND | | | GND | GND | | ||
| | RX | TX | | | RX | TX | | ||
| Line 48: | Line 57: | ||
| ==== Power Module to RFD868+ modem cable ==== | ==== Power Module to RFD868+ modem cable ==== | ||
| + | * 4x 8" JST already crimped cable | ||
| + | * JST 4-pin to female connector 8-pin | ||
| + | * GND + GND, 5V + 5V (double cable) | ||
| + | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
| - | t.b.d.Ìý | + | To mark the cable use colored shrink tube. |
| - | Ìý | + | |
| - | Ìý | + | |
| - | Ìý | + | |